Car Amplifiers
Zapco · Eton · Morel
Factory head units are current-limited and noisy. Adding a quality amplifier gives your speakers the clean power they need to perform properly — more volume, more detail, no distortion.
Amplifier Types
DSP Amplifiers
Digital signal processing built in — time alignment, crossovers, EQ and input switching all in one unit. The best upgrade for any system.
Multi-Channel Amps
4 or 6 channel amplifiers to power front and rear speakers cleanly. More headroom, less distortion than factory.
Mono / Sub Amps
High-current mono amplifiers built to drive subwoofers hard. 500W to 3000W+ for any build from daily to competition.
Signal Processors
Standalone DSPs and line drivers for complex multi-amp systems. Full control over every frequency in your setup.
Amplifier Brands We Stock
Zapco
Italian-engineered amplifiers trusted by competition audio installers worldwide. High-current, low-noise, built to push every speaker to its absolute limit. Zapco is the choice for serious installs.
- →ST-4X II — 4-channel
- →ST-2X II — 2-channel
- →ST-1000M — mono sub amp
- →DSP-Z8 IV — 8-channel DSP amp
Eton
German-engineered DSP amplifiers and power stages. Eton amps are built for audiophile accuracy — flat frequency response, minimal noise floor, and DSP integration that makes tuning straightforward.
- →MA1 — DSP amplifier
- →4-channel power stages
- →Underseat DSP amps
- →iDSP integration modules
Morel
Morel's MPS and MDSP amplifier series combine Israeli acoustic engineering with DSP processing. Built to match perfectly with Morel speakers for a complete reference-quality front stage.
- →MDSP series — DSP amps
- →MPS series — power stages
- →6-channel configurations
- →Matched to Morel speakers
Amp Installation Done Right
A poorly installed amp is worse than no amp — incorrect gain structure causes distortion and blows speakers. We set every amp correctly using a multimeter and oscilloscope. No guesswork.
Correct gain structure
Gains set with a multimeter and scope — not by ear. Prevents distortion and protects your speakers.
Proper power wiring
ZeroFlex or Stinger power cable, correct fusing at the battery, clean grounds — done to spec.
Remote turn-on
Amp turns on and off correctly with the head unit. No battery drain, no pop on power-up.
Ready to Add an Amp?
Tell us your vehicle and system goals — we'll recommend the right amplifier and handle the full install.
Unit 3, 289-339 Morayfield Rd, Morayfield QLD 4506